Untitled Document

20 Liter Storage Tank Parts Assembly

1- Lid
2- Float Control Box
3- Filler Tube
4- Gasket
5- Storage Tank
6- Left Leg
7- Right Leg
8- Acorn Nut
9- Stainless Steek Washer

10. Hex Nut
11. Plated Washer
12. Caster
13. Front & Back Trim
14. Faucet
15. Washer
16. Poly Nut
17. Side Trim

40 Liter Storage Tank Parts Assembly
Figure 1

Item #
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21

Part #
200056
400043
400041
400435
100052
100053
120005
300176
300108
400437
400474
300106
400436
300152
300015
120006
300113
300163
400531
140005
100051

Quantity
1
1
1
1
1
1
4
8
8
2
2
8
2
8
4
2
1
1
1
1
1

Description
Lid knob
Lid assembly
Float control box (FS-1 attached)
40 Liter storage tank body
4'' Filler tube
Filler tube gasket
Side trim (12 1/4")
Stainless Steel washers 5/16'' ID x 5/8'' OD
Stainless Steel acorn nuts
Leg assembly (left)
Leg support assembly
1/4-20 Hex nuts (packed on tank ends)
Leg assembly (right)
Plated washers 5/16'' ID x 3/4'' OD (packed on tank ends)
1/4-20 x 1 1/2'' Hex plated bolts
Front and back trim (19 7/8'')
3/8'' Hex nut (black poly) on faucet
Faucet washer
11 1/2'' Faucet with ring support
Faucet retainer (attached to tank)
Drain tube (see Figure3)

Maintenance

Maintenance of your Durastill Water Distiller

Once a week*
The evaporator tank of your distiller should be drained to remove the concentrated minerals and other impurities which collect during the distillation process. Unplug the distiller then open the drain valve to emply the evaporator tank. Rinse well and drain the rinsing water completely. ( It is recommended to add 1/4 teaspoon of ''Still Sweet'' scale minimizer before re-starting your distiller.)

Once a month*
Unplug the distiller, then, to the hot water add 2 tablespoons of ''Attitude" scale dissolver. Stir well and let mixture setle for 24 hours with tank lid off. Rinse well and drain evaporator tank a few times. Restart distiller.

* The two above procedures do not require to be done as ofter if you have a water softener-conditioner, since the hardness minerals that cause scale buildup would be removed and scaling would thus be minimized.

Once a year
Sterilizing procedure for your water distiller and water storage tank.

Unplug the water distiller and empty the water storage tank in containers. (This is distilled water; do not throw it away)! Take off and discard the used post-filter. Connect the distiller water outlet to the storage tank inlet.
Open the water storage tank faucet to allow steam to escape. Plug the distiller and turn the fan switch to ''OFF''.
This process will generate steam to sterilize the complete unit and exit through the storage tank faucet. Let the steam exit for 30 minutes then turn the fan switch to ''ON'' to let the system cool down. Once water storage is cool to the touch unplug the distiller and close the water storage tank faucet. (After writing today's date on a new post-filter, install it between the distiller and the water storage tank. Next year you will know when the time has come to sterilize your distiller and to change your post-filter.)

P.S. The pre-filter should also be changed once a year.

TELEPHONE 1-613-524-2177............FAX 1-613-524-3248

GREAT OPPORTUNITY FOR DEALERS
DURASTILL IS SEARCHING FOR WHOLESALERS TO COVER ONTARIO, QUEBEC AND THE MARITIMES


1. Float Bulb - 200082 1. Float Stem - 400001 3. Teflon Wrapped Float Guide - 400008 4. Float Gasket - Silicone ---- 5. Float Diaphragm - 400277	6. Washer Stainless Steel - 300177 7. Float Switch Actuator - 2000052 8. Stainless steel Float Washer - 1000024 9. Stainless Steel 1/4 x 20 Nut - 300125 10. Stainless Steel Washers ( 1/4 FCW) - 300176